4-330 MFP Service Manual
7500-XXX
Exit 2 sensor (standard bin full exit 2) removal
1. Remove the exit 2 unit assembly. See “Exit 2 unit assembly removal” on page 4-315.
2. Open the exit 2 unit assembly.
3. Remove the exit 2 left cover. See “Exit 2 left cover removal” on page 4-319.
4. Remove the exit 2 right cover. See “Exit 2 right cover removal” on page 4-320.
5. Disconnect the sensor (standard bin full exit 2) (A).
6. Release the hooks to the sensor (standard bin full exit 2) (A) from the exit 2 unit assembly.
7. Remove the sensor (standard bin full exit 2) (A).
A
Front
Hook
Connector
To Next Page
Loading...
