I-2 MFP Service Manual
7500-XXX
D
diagnostic aids 3-1
accessing service menus 3-1
diagnostic information 2-1
confirm the installation status 2-2
error code messages 2-13
service checks 2-40
start 2-1
using service checks 2-1
Diagnostic Menus
entering diagnostic menus 3-2
Diagnostics Menus
available tests 3-2
BASE SENSOR TEST 3-16
DEVICE TESTS 3-17
Disk Test/Clean 3-17
Quick Disk Test 3-17
DUPLEX TESTS
3-10
Quick Test 3-10
EVENT LOG 3-22
Clear the Event Log 3-24
Display the Event Log 3-22
Print the Event Log 3-24
FINISHER TESTS
Feed Tests 3-14
Hole Punch Test 3-14
Sensor Test 3-14
Staple Test 3-13
HARDWARE TESTS 3-7
Button Test 3-7
CACHE Test 3-9
DRAM Test 3-8
Panel Test 3-7
Parallel Wrap 3-9
INPUT TRAY TESTS
Feed Tests 3-10
Sensor Test 3-11
MOTOR TESTS 3-5
OUTPUT TRAY TESTS
Feed Tests 3-12
Feed To All Bins 3-12
Sensor Test 3-13
PRINT TESTS 3-6
PRINTER SETUP 3-19
Configuration ID 3-20
Defaults 3-19
Edge to Edge 3-21
Engine Setting 1 to 4 3-20
Model Name 3-20
Parallel Strobe Adjustment 3-22
Permanent Page Count 3-20
Printed Page Count 3-20
Serial Number 3-20
SCANNER TESTS
ASIC Test
3-25
Feed Test 3-25
Scanner Manual Registration 3-26
Scanner manual registration factory defaults 3-30
Sensor Test 3-31
Dial Pause button 2-4
down arrow button 2-10
duty cycle 1-3
E
emulation 1-2
error code messages 2-13
error codes
200.00 sensor (registration) off jam (too long)
2-40
200.01 sensor (registration) static on jam 2-41
201.00 sensor (fuser exit) on jam 2-42
202.00 sensor (fuser exit) off jam 2-43
202.01 sensor (fuser exit) off (too short) jam 2-44
202.02 sensor (fuser exit) static jam 2-45
203.00 sensor (exit 2) on jam 2-45
203.01 sensor (exit 2) off jam 2-47
203.02 sensor (exit 2) on jam in standard bin or finisher
2-49
203.03 sensor (exit 2) static jam 2-50
230.00 sensor (duplex wait) on jam 2-51, 2-52
230.01 sensor (duplex wait) static jam 2-54
231.00 sensor (registration) on jam (duplex paper feed)
2-54
231.01 sensor (registration) on jam (duplex paper feed)
2-56
241.00 sensor (pre-feed) on jam (tray 1 feed) 2-58
241.01 sensor (registration) on jam (tray 1 feed) 2-59
242.00 sensor (pre-feed) on jam (tray 2 feed) 2-60
242.01 sensor (tray 2 feed-out) on jam (tray 2 feed)
2-62
242.02 sensor (registration) on jam (tray 2 feed) 2-64
242.03 sensor (tray 2 feed-out) static jam 2-66
243.00 sensor (pre-feed) on jam (tray 3 media feed)
2-66
243.01 sensor (tray 3 feed-out) on jam (tray 3 media
feed)
2-68
243.02 sensor (tray 2 feed-out) on jam (tray 3 media
feed)
2-70
243.03 sensor (registration) on jam (tray 3 media feed)
2-71
243.04 sensor (tray 3 feed-out) static jam 2-73
244.00 sensor (tray 4 feed-out) on jam (tray 4 media
feed)
2-74
244.01 sensor (tray 3 feed-out) on jam (tray 4 media
feed)
2-77
244.02 sensor (pre-feed) on jam (tray 4 media feed)
2-79
244.03 sensor (registration) on jam (tray 4 media feed)
2-81
244.04 sensor (pre-feed) on jam (tray 4 media feed)
2-82
244.05 sensor (tray 4 feed-out) static jam 2-84
250.00 sensor (registration) on jam (MPF pick) 2-85
290.00 switch (sheet through) static jam 2-87
290.01 sensor (sheet through) on jam 2-87
290.02 sensor (ADF pre-registration) on jam ADF
simplex side
2-90
290.03 sensor (ADF pre-registration) off jam 2-92
290.10 sensor (ADF pre-registration) static jam 2-94
To Next Page
Loading...
