4-4 Service Manual
7541-03x
Removal procedures
Arrangement of removals in this chapter
The removals in this chapter are arranged by area of printer. The areas are as follows:
“Cover Removals” on page 4-5
“Top removals” on page 4-26
“Front removals” on page 4-40
“Left side removals” on page 4-45
“Right side removals” on page 4-61
“Rear removals” on page 4-73
“Scanner area removals” on page 4-113
In addition to the sections, the duplex unit, and paperfeed unit sub-component removals have their own
sections. They are:
“Duplex unit component removals” on page 4-173
“Paperfeed unit component removals” on page 4-178
Note: Some removal procedures require removing cable ties. You must replace cable ties during reassembly to
avoid pinching wires, obstructing the paper path, or restricting mechanical movement.
CAUTION
Remove the power cord from the electrical outlet before you connect or disconnect any cable
or electronic board or assembly for personal safety and to prevent damage to the printer.
Disconnect any connections between the printer and PCs/peripherals.
To Next Page
Loading...
