4-10 Service Manual
7541-03x
7. Remove the screw (F) in the upper left corner of the cover.
8. Open the duplex unit and remove the one plastite screw that secures the cover to the side frame.
9. Remove the option connector cover.
10.Use the flatblade screwdriver to pry the rear cover away from the side cover at the main fan.
11.Use a small flatblade screwdriver to release the tabs (G) that fasten the option connector cable to the rear
cover.
12.Pull the rear cover away from the device.
Note: If there are ISP cards installed, remove the thumbscrews from the RIP cage.
To Next Page
Loading...
