Repair information 4-111
7541-03x
HVPS removal
1. Remove the rear cover. See “Rear cover” on page 4-7.
2. Remove the top cover. See “Output bin (print engine top) cover” on page 4-17.
3. Remove rear EMI shield. See “Rear EMI shield – Not a FRU” on page 4-106.
4. Remove three screws (A) attaching the HVU to the frame.
Note: The upper left screw is different than the other two.
5. Pinch the nylon retainer (B) to free the board.
To Next Page
Loading...
