Lexmark X925 7541-03 series - Static Discharge Brush Removal; Torque Limiter Removal; Upper and Lower Registration Springs Removal

4-186 Service Manual
7541-03x
Go Back
Previous
Next
Static discharge brush removal
1. Remove the paperfeed unit. See “Power supply fan removal” on page 4-55.
2. Remove the six screws (A) that secure the discharge brush plate to the paperfeed unit.
Torque limiter removal
1. Remove the separator roll. See “Separator roll removal” on page 4-189.
2. Remove the torque limiter.
Upper and lower registration springs removal
1. Remove the paperfeed unit. See “Power supply fan removal” on page 4-55.
2. Remove the clutches on the paperfeed unit. See “Paperfeed unit clutch removal” on page 4-184.
3. Separate the two paperfeed units. See “Separating the MPF tray and main tray paperfeed units” on
page 4-178.