PCL
2-58
ESC
&l#D
1 1 line/inch
2 2 lines/inch
3 3 lines/inch
4 4 lines/inch
6 6 lines/inch (Default)
8 8 lines/inch
12 12 lines/inch
16 16 lines/inch
24 24 lines/inch
48 48 lines/inch
Set Line Spacing (Alternative Method)
Specifies VMI in lines per inch.
Notes:
• For some printers, you can change the default VMI from the printer
control panel or through MarkVision Professional by using the Lines
Per Page menu item. See your printer documentation for more
information.
• Unsupported values are ignored.
• Use of this command alters any earlier VMI setting.
E
SC
&a#G
0Next Side
1Front Side
2 Back Side
Duplex Page Side Selection
Specifies which physical page side to print next when duplex printing.
Note: When the duplex option is not installed, this command causes a
conditional page eject.
ESC
&l#P
# = number from 0 to 14
0 = default page length is used
(1 to 14 = new page length is set)
Set Page Length
Sets the logical page length in number of lines.
Notes:
• This command is sent at the beginning of a page in a print job and
prior to any printable data.
• When the command is sent, the current page is closed and printed.
• Unsupported values are ignored.
ESC
&k#W
5 Turn Text Scale Mode OFF
6 Turn Text Scale Mode ON
Text Scale Mode
Allows 66 lines of text at six lines per inch to print on an effective page
length of 10 1/2 inches.
Notes:
• Unsupported values are ignored.
• The command is ignored when the printer is in landscape mode.
Table 2-17: Page Control (Continued)
Command / Parameters Function / Result
To Next Page
Loading...
