Lexmark X945e MFP 7510 series User Manual

Diagnostic information 2-37
7510
Go Back
Previous
Next
991.13
Service finisher
error
Booklet unit maker error Booklet set recovery was detected too many times
for the same job. Perform a POR.
Refer to the Finisher Service Manual.
992.00
Service finisher
error
Sensor (de-curler clutch HP)
late error
The sensing area of the sensor (de-curler cam HP)
is not interrupted within the specified time after the
de-curler roll assembly (nip) starts moving to the
home position.
Refer to the Finisher Service Manual.
992.01
Service finisher
error
Sensor (de-curler clutch HP)
lag error
The sensing area of the sensor (de-curler cam HP)
remains interrupted within the specified time after
the de-curler roll assembly (nip) starts moving from
the home position.
Refer to the Finisher Service Manual.
Close cover F Bridge unit cover is open. The bridge unit assembly cover is open.
Refer to the Finisher Service Manual.
Close door A Printer left door open. The printer left door assembly is open, or the printer
left door closed actuator is damaged.
Go to “Printer left door open” on page 2-207.
Close door B Duplex left door assembly
open.
The Duplex left door assembly is open.
Go to “Duplex left door assembly open” on
page 2-201.
Close door C Printer left lower door
assembly open
The printer lower left door assembly is open.
Go to “Printer left lower door assembly open” on
page 2-209.
Close door D 1TM, 3TM or TTM left door
assembly open
The 1TM, 3TM or TTM tray left door assembly is
open.
Go to “1TM, 3TM or TTM left door assembly
open” on page 2-200.
Close door E Printer front door assembly
open
Printer front door assembly is open.
Go to “Printer front door assembly open” on
page 2-206.
Close door G Finisher front door open. The finisher front door is open.
Refer to the Finisher Service Manual.
Close door J Transfer belt access door
open.
The transfer belt access door is open.
Go to “Transfer belt access door open” on
page 2-208.
Close
surface H
Eject cover open. The finisher eject cover is open.
Refer to the Finisher Service Manual.
Empty hole
punch box
Punch waste box full. The punch waste box is full.
Refer to the Finisher Service Manual.
Insert hole
punch box
Punch waste box missing. No punch waste box.
Refer to the Finisher Service Manual.
Load staples Staple cartridge empty. Staple cartridge empty.
Refer to the Finisher Service Manual.
Error code or
message
Error contents Description/Action

Lexmark X945e MFP 7510 series Specifications

General

Brand	Lexmark
Model	X945e MFP 7510 series
Category	Printer
Language	English