Lexmark X945e MFP 7510 series - Fuser Cooling Fan Removal

Repair information 4-101
7510
Go Back
Previous
Next
13. Remove the 24V LVPS card bracket assembly. See “24V LVPS card bracket assembly removal” on
page 4-95.
14. Remove the CMYK transfer HVPS card assembly. See “CMYK transfer HVPS card assembly removal”
on page 4-103
15. Remove the K developer transport drive motor assembly. See “K developer / transport drive motor
assembly removal” on page 4-106.
16. Remove the two connectors from the CMYK PC cartridge drive motor assembly (A).
17. Release the hook securing the access cover (B) to the machine.
18. Remove the access cover (B).
19. Remove the two screws securing the socket (C) to the machine.
20. Detach the socket (C) from the machine.
Note: The lower left screw can be accessed through the hole in the frame where the socket (B) was
detached in step 7.
21. Remove the eight screws securing the CMY PC cartridge drive motor assembly (A) to the machine.
22. When removing the CMYK PC cartridge drive motor assembly (A), ensure none of the harnesses become
damaged.
23. Remove the CMYK PC cartridge drive motor assembly (A).
Fuser cooling fan removal
1. Remove the rear cover assembly. See “Rear cover assembly removal” on page 4-5.
2. Remove the right cover assembly. See “Right cover assembly removal” on page 4-4.
3. Remove the top cover assembly. See “Top cover assembly removal” on page 4-4 or “Rear cover
assembly removal” on page 4-5.
4. Disconnect the connector from the fuser cooling fan (A).
5. Remove the harness from the clamps.
6. Lift the fuser cooling fan (A).
Connector
A
Connector
B
C
Screwdriver
access hole