4-124 Service Manual
7510
Large platen glass removal
1. Remove the two screws securing the large platen glass retainer (A) to the scanner unit assembly.
2. Remove the large platen glass retainer (A).
3. Gently lift the large platen glass (B) upward, and move it rightward in the direction of the arrow.
4. Remove the large platen glass (B).
Warning: Do not drop the large platen glass (B), or damage will occur.
Note: Avoid touching the underside of the large platen glass (B).
Note: Before reinstalling the large platen glass (B), clean the underside with glass cleaner, and then install
the large platen glass assembly (B). After installation, clean the top of the large platen glass (B) with glass
cleaner.
Scanner left cover removal
1. Remove the two screws securing the scanner left cover (A) to the scanner unit assembly.
2. Disengage the rear side of scanner left cover (A) from the scanner unit assembly, and shift the scanner left
cover (A) rearward.
3. Release the two hooks securing the front side of scanner left cover (A), and remove the scanner left cover
(A).
To Next Page
Loading...
