Lexmark X945e MFP 7510 series - Page 701

Repair information 4-269
7510
Go Back
Previous
Next
3
Analyze the fine skew setup.
1. Enter the Diagnostics Menu.
2. Touch ENGINE ADJUST.
3. Touch RegCon adjust
4. Touch Control setup cycles
5. Touch Cycle result values
Locate the following new values for the following settings:
Patch-B in
Patch-B out
Is the value for both of the above settings a “4”?
Go to step 4. Go to step 6.
4
Perform the skew rough setup.
1. Enter the Diagnostics Menu.
2. Touch ENGINE ADJUST.
3. Touch RegCon adjust
4. Touch Control setup cycles
5. Touch Skew rough setup
Does the above test pass?
Go to step 5. Go to step 6.
Step Check Yes No