2-30 Service Manual
7510
925.00
Service PC
cartridge
Sensor (Y ATC) Outputs of the sensor (Y ATC) are not in the
specified range.
This error must be reset inside diagnostic mode
before troubleshooting or machine operation can
occur.
Go to “925.00 Sensor (Y ATC) error” on
page 2-162.
925.01
Service PC
cartridge
Sensor (M ATC) Outputs of the sensor (M ATC) are not in the
specified range.
This error must be reset inside diagnostic mode
before troubleshooting or machine operation can
occur.
Go to “925.01 Sensor (M ATC) error” on
page 2-163.
925.02
Service PC
cartridge
Sensor (C ATC) Outputs of the sensor (C ATC) are not in the
specified range.
This error must be reset inside diagnostic mode
before troubleshooting or machine operation can
occur.
Go to “925.02 Sensor (C ATC) error” on
page 2-163.
925.03
Service PC
cartridge
Sensor (K ATC) Outputs of the sensor (K ATC) are not in the
specified range.
This error must be reset inside diagnostic mode
before troubleshooting or machine operation can
occur.
Go to “925.03 Sensor (K ATC) error” on
page 2-164.
940.00
Service MPF
failure
MPF Tray 5 size sensing
error
The MPF size width sensor has failed.
Go to “940.00 MPF tray 5 size sensing error” on
page 2-164.
941.00
Service tray 1
failure
Switch (media size) size
sensing error (tray 1)
The tray 1 switch (media size) detected an invalid
size setting.
Go to “941.00 Switch (media size) size sensing
error (tray 1)” on page 2-165.
941.01
Service tray 1
failure
sensor (media level) late
error (tray 1)
The sensing area of the sensor (media level) in the
media tray 1 is not interrupted within the specified
time after the lift tray has risen to operating level.
Go to “941.01 Sensor (media level) late error
(tray 1)” on page 2-166.
942.00
Service tray 2
failure
Switch (media size) size
sensing error (tray 2)
The tray 2 switch (media size) detected an invalid
size setting.
Go to “942.00 Switch (media size) size sensing
error (tray 2)” on page 2-167.
942.01
Service tray 2
failure
Sensor (media level) late
error (tray 2)
The sensing area of the sensor (media level) in the
media tray 2 is not interrupted within the specified
time after the lift tray has risen to operating level.
Go to
“942.01 Sensor (media level) late error
(tray 2)” on page 2-167.
Error code or
message
Error contents Description/Action
To Next Page
Loading...
