Lexmark X95 series - Heat Belt Rotation Failure; Fuser Temperature Recovery Failure; Incorrect Fuser

Diagnostic information 2-59
7558-xxx
Go Back
Previous
Next
121.10 Heat belt rotation failure
121.11 Fuser temperature recovery failure
121.12 Incorrect fuser
3
POR the machine.
Does the error continue?
Replace the upper printer engine
PCBA.
Go to “Upper printer engine
PCBA removal” on page 4-187.
Problem resolved
Step Action and questions Yes No
1 Check the fuser assembly.
Is the above component
properly connected?
Go to step 2. Remove foreign particles, and
replace the connections.
2
Replace the fuser assembly. Go
to “Fuser assembly removal”
on page 4-84.
Does the error remain?
Go to step 3. Problem resolved
3
POR the machine.
Does the error continue?
Replace the upper printer engine
PCBA.
Go to “Upper printer engine
PCBA removal” on page 4-187.
Problem resolved
Step Action and questions Yes No
1 Check the fuser assembly.
Is the above component
properly connected?
Go to step 2. Remove foreign particles, and
replace the connections.
2
Replace the fuser assembly. Go
to “Fuser assembly removal”
on page 4-84.
Does the error remain?
Go to step 3. Problem resolved
3
POR the machine.
Does the error continue?
Replace the upper printer engine
PCBA.
Go to “Upper printer engine
PCBA removal” on page 4-187.
Problem resolved
Step Action and questions Yes No
1 POR the machine.
Does the error continue?
Replace the fuser assembly. Go
to “Fuser assembly removal”
on page 4-84.
Problem resolved
Step Action and questions Yes No