Lexmark X95 series - Booklet Media Pinch Roll Assembly Removal; Booklet Paddle Drive Motor Assembly Removal

4-330 Service Manual
7558-xxx
Go Back
Previous
Next
6. Remove the booklet media entrance drive motor (A).
Booklet media pinch roll assembly removal
1. Remove the booklet unit chassis. See “Booklet unit chassis removal” on page 4-335.
2. Remove the sensor (booklet media entrace). See “High capacity feeder (HCF) removal procedures” on
page 4-429.
3. Remove the four screws securing the frame X from the booklet unit chassis.
4. Release the cable harness from the frame X.
5. Remove the four screws securing the booklet media pinch roll assembly (A) from the booklet unit chassis.
6. Remove the booklet media pinch roll assembly (A).
Booklet paddle drive motor assembly removal
1. Remove the booklet unit assembly. See “Booklet unit chassis removal” on page 4-335.
2. Remove the booklet unit assembly left cover. See “Booklet unit assembly left cover removal” on
page 4-334.
A
Connector
Rear
A
B