Lexmark X95 series - Page 896

4-418 Service Manual
7558-xxx
Go Back
Previous
Next
4. Disconnect the connector from the stepper motor (exit).
5. Remove the two screws securing the bracket (D) to the finisher.
6. Remove the bracket (D).
7. Remove the two screws securing the stepper motor (exit) to the bracket (D).
8. Remove the stepper motor (exit) (C).
Replacement notes:
• The tension of the belt (exit) (B) is automatically adjusted by the force of the spring attached to the belt
tensioner bracket (A).
• Tighten the two screws in the order shown.
A
B
C
A
Rear
Second
First
Connector
D
C
Connector