530
8-2. Steps to take in an emergency
IS250_EE(OM53B11E)
Avoiding battery fires or explosions
Observe the following precautions to prevent accidentally igniting the flamma-
ble gas that may be emitted from the battery:
Make sure each jumper cable is connected to the correct terminal and that it is
not unintentionally in contact with any other than the intended terminal.
Do not allow the other end of the jumper cable connected to the “+” terminal
to come into contact with any other parts or metal surfaces in the area, such as
brackets or unpainted metal.
Do not allow the + and - clamps of the jumper cables to come into contact
with each other.
Do not smoke, use matches, cigarette lighters or allow open flame near the
battery.
Battery precautions
The battery contains poisonous and corrosive acidic electrolyte, while related
parts contain lead and lead compounds. Observe the following precautions
when handling the battery:
When working with the battery, always wear safety glasses and take care not
to allow any battery fluids (acid) to come into contact with skin, clothing or
the vehicle body.
Do not lean over the battery.
In the event that battery fluid comes into contact with the skin or eyes, imme-
diately wash the affected area with water and seek medical attention.
Place a wet sponge or cloth over the affected area until medical attention can
be received.
Always wash your hands after handling the battery support, terminals, and
other battery-related parts.
Do not allow children near the battery.
When handling jumper cables
When connecting the jumper cables, ensure that they do not become entangled
in the cooling fans or engine drive belt.
To Next Page
Loading...
