Lexus 2015 CT200H - Page 444

444
CT200h_OM_OM76134U_(U)
6-4. Using the other interior features
Press and hold the programmed
HomeLink
®
button (located
inside the vehicle) for 2 seconds
and release it. Repeat this
sequence (press/hold/release)
up to 3 times to complete pro-
gramming.
If the garage door opener motor
activates when the HomeLink
®
but-
ton is pressed, the garage door
opener motor recognizes the
HomeLink
®
signal.
■ Enabling 2-way communication with a garage door (only available for com-
patible devices)
When enabled, 2-way communication allows you to check the status of the
opening and closing of the garage door through indicators in your vehicle.
2-way communication is only available if the garage door opener motor used
is a compatible device. (To check device compatibility, refer to the Owner’s
manual supplied with the garage door opener motor.)
Press a programmed HomeLink
®
button to operate a garage door.
Within 1 minute of pressing the HomeLink
®
button, after the garage door
operation has stopped, press the “learn” or “smart” button on the garage
door opener motor. Within 5 seconds of the establishment of 2-way com-
munication with the garage door opener, both garage door operation indi-
cators in the vehicle will flash rapidly (green).
■ Reprogramming a single HomeLink
®
button
When the following procedure is performed, buttons which already have
devices registered to them can be overwritten:
With one hand, press and hold the desired HomeLink
®
button.
When the HomeLink
®
indicator starts flashing, continue to hold the
HomeLink
®
button and perform “Programming HomeLink
®
” from step
(it takes 20 seconds for the HomeLink
®
indicator to start flashing).
3
1
2
1
2
1