204
2-2. Instrument cluster
■ Electronic features control can be turned on/off when
The “ENGINE START STOP” switch is in IGNITION ON mode.
■ Conditions for ending electronic features control
In the following situations, the electronic features control will end:
● The menu switch is pressed.
● The dynamic radar cruise control is operated (if equipped).
● Intuitive parking assist starts operating (if equipped).
● No action is performed for some time after the electronic features control
screen is displayed.
● A warning message appears after the electronic features control screen is dis-
played.
■ Eco Driving Indicator
■ Outside temperature display
In the following situations, the correct outside temperature may not be displayed, or
the display may take longer than normal to change.
● When stopped, or driving at low speeds (less than 16 mph [25 km/h])
● When the outside temperature has changed suddenly (at the entrance/exit of a
garage, tunnel, etc.)
Eco Driving Indicator Light
During Eco-friendly acceleration (Eco
driving), Eco Driving Indicator Light will
turn on.
Eco Driving Indicator Zone Display
Suggests Eco driving range with current
Eco driving ratio based on acceleration.
Zone of Eco driving
Eco driving ratio based on acceleration
If Zone of Eco driving is exceeded, the
right of Eco Driving Indicator Zone Dis-
play will blink and Eco Driving Indicator
Light will turn off.
To Next Page
Loading...
