118
GS350_200t_GS F_OM_OM30E86U_(U)
2. Instrument cluster
■ Start-up display
When the engine is started, the name of the vehicle is displayed on the multi-information
display.
While the start-up display is being displayed, the meter display cannot be changed even
if the drive mode is changed. When the start-up display is finished, the meter display for
the currently selected mode will be displayed.
■ Torque distribution display
Torque distribution may not be displayed correctly in some cases, such as when the vehi-
cle passes over road expansion joints.
■ G-force display
● The G-force values may not be zero even when the vehicle is parked, such as when it is
parked on an incline.
● The steering amount, accelerator pedal input, and brake fluid pressure displays are dis-
abled until the engine has warmed up (the variable red zone of the tachometer has
retracted to 7300 rpm).
After the engine has warmed up, these displays will be enabled.
● Depending on the vehicle usage conditions, the brake fluid pressure display may not
reach its maximum reading even though the brake pedal is fully depressed.
● If a battery terminal is disconnected and reconnected, the steering amount display may
be disabled temporarily. After driving the vehicle for a while, the display will be enabled.
■ Suspension of the settings display
In the following situations, operation of the settings display will be temporarily sus-
pended.
● When a warning message appears on the multi-information display
● When the vehicle begins to move
■ Tire inflation pressure
● It may take a few minutes to display the tire inflation pressure after the engine switch is
turned to IGNITION ON mode. It may also take a few minutes to display the tire infla-
tion pressure after inflation pressure has been adjusted.
● “---” may be displayed if the tire position information cannot be determined due to
unfavorable radio wave conditions.
● Tire inflation pressure changes with temperature. The displayed values may also be dif-
ferent from the values measured using a tire pressure gauge.
■ When disconnecting and reconnecting battery terminals
The following information data will be reset:
● Lap timer: Measured lap times, history
● G-force: Record of the maximum G-forces
■ Using the lap timer
If the engine is stopped while a lap is being timed, the lap timer will stop and the lap time
up to that point will be recorded.
■ Liquid crystal display
P. 98
To Next Page
Loading...
