236
CT200h_OM_OM76174U_(U)
4-5. Using the driving support systems
Hill-start assist control
To engage hill-start assist control, fur-
ther depress the brake pedal when the
vehicle is stopped completely.
A buzzer will sound once to indicate the
system is activated. The slip indicator
will also start flashing.
■ Hill-start assist control operating conditions
● The system operates in the following situations:
• The shift position is in a position other than P.
• The parking brake is not applied.
• The accelerator pedal is not depressed.
● Hill-start assist control cannot be operated while the slip indicator light is illuminated.
■ Hill-start assist control
● While hill-start assist control is operating, the brakes remain automatically applied after
the driver releases the brake pedal. The stop lights and the high mounted stoplight turn
on.
● Hill-start assist control operates for about 2 seconds after the brake pedal is released.
● If the slip indicator does not flash and the buzzer does not sound when the brake pedal
is further depressed, slightly reduce the pressure on the brake pedal (do not allow the
vehicle to roll backward) and then firmly depress it again. If the system still does not
operate, check if the operating conditions explained above have been met.
Assists with starting off and temporarily maintains braking power even if the
foot is removed from the brake pedal when starting off on an incline or a slip-
pery slope.
To Next Page
Loading...
