135
2. Instrument cluster
2
Instrument cluster
GS350_300_GS F_OM_OM30J17E_(GE)
■ Tire inflation pressure (if equipped)
● It may take a few minutes to display the tire inflation pressure after the engine switch is
turned to IGNITION ON mode. It may also take a few minutes to display the tire infla-
tion pressure after inflation pressure has been adjusted.
● “---” may be displayed if the tire position information cannot be determined due to
unfavorable radio wave conditions.
● Tire inflation pressure changes with temperature. The displayed values may also be dif-
ferent from the values measured using a tire pressure gauge.
■ When disconnecting and reconnecting battery terminals
The following information data will be reset:
● Lap timer: Measured lap times, history
● G-force: Record of the maximum G-forces
■ Using the lap timer
If the engine is stopped while a lap is being timed, the lap timer will stop and the lap time
up to that point will be recorded.
■ Liquid crystal display
P. 107
■ Caution for use while driving
● When operating the multi-information display while driving, pay extra attention to the
safety of the area around the vehicle.
● Do not look continuously at the multi-information display while driving as you may fail
to see pedestrians, objects on the road, etc. ahead of the vehicle.
■ Cautions during setting up the display
As the engine needs to be running during setting up the display, ensure that the vehicle
is parked in a place with adequate ventilation. In a closed area such as a garage,
exhaust gases including harmful carbon monoxide (CO) may collect and enter the
vehicle. This may lead to death or a serious health hazard.
■ During setting up the display
To prevent battery discharge, ensure that the engine is running while setting up the dis-
play features.
To Next Page
Loading...
