ELECTRICAL COMPONENTS
415
1
Terminals
2
Hold–down clamp
Check the battery for corroded or loose connections,
cracks, or loose hold–down clamps.
1. If the battery is corroded, wash it off with a solution of
warm water and baking soda. Coat the terminals with grease
to prevent further corrosion.
2. If the connections are loose, tighten the clamp bolts – but
do not overtighten.
3. Tighten the hold–down clamp only enough to keep the
battery firmly in place. Overtightening may damage the
battery case.
NOTICE
Make sure the engine and all accessories are turned
off before performing maintenance.
When checking the battery, remove the ground cable
first and reinstall it last.
Be careful not to cause a short circuit with tools.
Take care no solution gets into the battery when
washing it.
Checking battery fluid
There are 2 types of batteries: maintenance type and
non–maintenance type.
A non–maintenance battery has ”MAINTENANCE FREE
BATTERY” on its top. A maintenance type battery does not
have such indication.
Maintenance type battery
Check the fluid condition by the fluid level lines on the side
of the battery. Or if the battery has a hydrometer on its top,
you can also check the hydrometer.
Non–maintenance battery
Check the battery condition by the hydrometer on the top of
the battery.
To Next Page
Loading...
