INTERIOR EQUIPMENT
117
Programming other devices
To program other devices such as home security systems,
home door locks or lighting, contact your authorized Lexus
dealer for assistance.
Reprogramming a button
Individual HomeLink
buttons cannot be erased, however, to
reprogram a single button, follow the procedure “Programming
the HomeLink
”.
INFORMATION
Keep your hand−held garage transmitter even after
programming. The hand−held garage transmitter will
be required if reprogramming is necessary.
(b) Operating the HomeLink
To operate the HomeLink
, press the appropriate HomeLink
button to activate the programmed device. The HomeLink
indicator light should come on. If the “Rolling Code” type
program is registered, the HomeLink indicator light flashes
several times, then remains on. The HomeLink
continues to
send the signal for up to 20 seconds as long as the button is
pressed.
INFORMATION
The transmitting range from the HomeLink may differ
from that from your hand−held garage transmitter.
(c) Erasing the entire HomeLink
memory
(all three programs)
G14061
To erase all previously programmed codes at one time, press
and hold down the 2 outside buttons for 20 seconds until the
indicator light flashes.
If you sell your vehicle, be sure to erase the programs stored
in the HomeLink
memory.
To Next Page
Loading...
