REMOTE ENGINE STARTER*
a ) Starting the Engine
1. Close and lock all doors.
2. Quickly press
twice and then press and hold
for 3 seconds.
NOTE:
When the engine starts, the hazard lights will fl ash for
20 seconds.
b ) Stopping the Engine
1. Press
or press and hold for 2 seconds.
POWER SUPPLY CHANGEOVER AND
ENGINE START/STOP
Check for proper activation of the “ENGINE” switch.
Power supply changeover
a ) Carry the electronic key in the vehicle and apply the
parking brake.
b ) Without depressing the brake pedal, press the
“ENGINE” switch and change the power supply.
OFF
Press once: ACCESSORY mode
Press twice: “IG-ON” mode
Press three times: OFF
c ) In each mode, check that the power supply has changed
properly.
NOTE:
If the “ENGINE” switch illuminator blinks refer to the Repair
Manual.
Engine start/stop
a ) Carry the electronic key in the vehicle and apply the
parking brake.
b ) Check that the shift lever is in the “P” position.
c ) When depressing the brake pedal, check that the green
“ENGINE” switch illuminator comes on, push the
“ENGINE” switch to start the engine.
d ) Press the “ENGINE” switch regardless of brake position
to stop the engine.
1
2
3
1
* If equipped
15
GX 460
INSPECTION DETAILS - B. LOCKS AND LIGHTS
To Next Page
Loading...
