SEAT POSITION MEMORY SYSTEM*
a ) With the “ENGINE” switch in the “IG-ON” mode and the
shift lever in “P” position, check the operation:
1. Adjust the driver’s seat, tilt and telescopic steering
wheel and outside rear view mirrors to the desired
positions.
2. While pressing the “SET” button, press down the
button “1” or “2” until a beep is heard.
3. Check all buttons (1 and 2) to make sure that all
memorized settings operate correctly.
b ) With the engine switch in the “OFF” mode, close the
driver’s door.
1. Register a driving position to the button “1” or “2”.
2. Do not carry more than one key (including a card
key*) when registering. While pressing the button “1”
or “2”, press the driver’s door lock switch (either
lock or unlock switch) until a signal beeps.
3. Unlock the driver’s door using the entry function or
wireless remote control, open the driver’s door, and
check that the stored driving position is recalled.
* If equipped
21
GX 460
INSPECTION DETAILS - C. LEFT FRONT
To Next Page
Loading...
