INTUITIVE PARKING ASSIST*
This procedure is performed by placing poles
(Ø 2.36 in) or safety cones at 6 points:
a ) With the “ENGINE” switch in the “IG-ON” mode,
press the menu switch and press the “ENTER”
switch upwards or downwards until intuitive parking
assist mark appears.
b ) Check that the indicator light will illuminate when
“ON” is selected by pressing “ENTER” switch.
NOTE:
One beep sounds.
c ) The poles or safety cones gradually approach the
vehicle.
About 3.3 ft. (100 cm)
About 4.9 ft. (150 cm)
About 2.0 ft. (60 cm)
About 1.8 ft (55 cm)
d ) Check that the buzzer sounds and the indicator bar is
displayed on the screens.
Front corner sensor operation
Front center sensor operation
Rear corner sensor operation
Rear center sensor operation
Front tire angle
Check that the interval of the buzzer shortens and
ultimately changes to a continuous sound as the
obstacle is approached.
* If equipped
1
2
3
4
1
2
3
4
5
U9001LI
Multi-information Display
Accessory meter
Navigation screen
32
GX 460
INSPECTION DETAILS - C. LEFT FRONT
To Next Page
Loading...
