GX460_OM_OM60U05U_(U)
451
5-5. Using the other interior features
5
Interior features
■ Before programming HomeLink
®
● During programming, it is possible that garage doors, gates, or other
devices may operate. For this reason, make sure that people and objects
are clear of the garage door or other devices to prevent injury or other
potential harm.
● It is recommended that a new battery be placed in the remote control
transmitter for more accurate programming.
● Garage door opener motors manufactured after 1995 may be equipped
with rolling code protection. If this is the case, you may need a stepladder
or other sturdy, safe device to reach the “Learn” or “Smart” button on the
garage door opener motor.
■ Programming the HomeLink
®
Steps through must be performed within 60 seconds, otherwise the
indicator light will stop flashing and programming will not be able to be com-
pleted.
Press and release the HomeLink
®
button you want to program and check
that the HomeLink
®
indicator light flashes (orange).
Point the remote control transmit-
ter for the device at the rear view
mirror, 1 to 3 in. (25 to 75 mm)
from the HomeLink
®
buttons.
Keep the HomeLink
®
indicator light
in view while programming.
To Next Page
Loading...
