46
1-3. Adjustable components (seats, mirrors, steering wheel, etc.)
■ Retained accessory power
Each memorized position (except for the tilt and telescopic steering column) can
be activated within 30 seconds after the driver’s door is opened, even if the key is
not in the engine switch.
■ If any position memory button is pushed while the adjustments are being made
The operation will stop. To reactivate the system, push the button again.
■ If the battery is disconnected
The memorized positions must be reset because the computer’s memory is erased
when the battery is disconnected.
■ Seat adjustment caution
Take care during seat adjustment that the seat does not strike the rear passenger or
squeeze your body against the steering wheel.
If this happens, you can stop the movement by pressing another seat position mem-
ory button.
■ Recalling the memorized position
Check that the shift lever is set in “P”.
Turn the engine switch to the “ON” position.
Push button “1” or “2” to recall
the desired position.
STEP 1
STEP 2
To Next Page
Loading...
