KEYS AND DOORS
26
Setting the functions
1. Close all the doors.
2. Turn the ignition switch to the “ON” position.
3. Within 10 seconds after the ignition switch is turned to the
“ON” position;
To set function (a)
Push and hold the front of the power door lock switch for 5
seconds with the selector lever in the “P” position.
To set function (b)
Push and hold the rear of the power door lock switch for 5
seconds with the selector lever in the “P” position.
To set function (c)
Push and hold the front of the power door lock switch for 5
seconds with the selector lever in any position except “P”.
To set function (d)
Push and hold the rear of the power door lock switch for 5
seconds with the selector lever in any position except “P”.
All the doors automatically lock and unlock when you release
the power door lock switch. This indicates that the function is
set. If all the doors do not lock and unlock, the time the switch
was held may have been too short or too long. Perform the
procedure over again starting from step 1.
If you want to cancel a function, repeat the procedure. Each
time you perform the procedure, the function is set or
cancelled.
To Next Page
Loading...
