120
3-2. Opening, closing and locking the doors
The power back door system can be
enabled/disabled on the center dis-
play. (P.572)
1 Select on the center display.
2 Select “Vehicle customize”.
3 Select “Door control”.
4 Select “Power back door”.
5 Select (ON)/
(OFF).
When OFF is selected and the operations
of the power back door is made to stop
from the center display, unless it is set to
ON, the operation of the power back door
will not return. (No return in the engine
switch operation)
The Hands Free Power Back Door
(kick sensor) can be enabled/disabled
on the center display. (P.572)
1 Select on the center display.
● Keep the right lower part of the rear
bumper clean at all times.
If the right lower part of the rear bumper
is dirty or covered with snow, the Hands
Free Power Back Door may not operate.
In this situation, clean off the dirt or snow,
move the vehicle from the current posi-
tion and then check if the Hands Free
Power Back Door operates.
If it does not operate, have the vehicle
inspected by your Lexus dealer.
● Do not apply coatings that have a rain
clearing (hydrophilic) effect, or other
coatings, to the right lower part of the
rear bumper.
● Do not park the vehicle near objects
that may move and contact the right
lower part of the rear bumper, such as
grass or trees.
If the vehicle has been parked for a while
near objects that may move and contact
the right lower part of the rear bumper,
such as grass or trees, the Hands Free
Power Back Door may not operate. In
this situation, move the vehicle from the
current position and then check if the
Hands Free Power Back Door operates.
If it does not operate, have the vehicle
inspected by your Lexus dealer.
● Do not subject the rear bumper or its
surrounding area to a strong impact.
If the rear bumper or its surrounding
area has been subjected to a strong
impact, the Hands Free Power Back
Door may not operate properly. If the
Hands Free Power Back Door does not
operate in the following situations, have
the vehicle inspected by your Lexus
dealer.
• The kick sensor or its surrounding area
has been subjected to a strong impact.
• The right lower part of the rear
bumper is scratched or damaged.
● Do not disassemble the rear bumper.
● Do not attach stickers to the rear
bumper.
● Do not paint the rear bumper.
● If a bicycle carrier or similar heavy
object is attached to the power back
door, disable the Hands Free Power
Back Door (kick sensor).
Canceling the power back door
system
Canceling the Hands Free
Power Back Door (if equipped)
To Next Page
Loading...
