121
3-2. Opening, closing and locking the doors
3
Before driving
2 Select “Vehicle customize”.
3 Select “Door control”.
4 Select “Hands free”.
5 Select (ON)/
(OFF).
When OFF is selected and the operations
of the Hands Free Power Back Door is
made to stop from the center display,
unless it is set to ON, the operation of the
Hands Free Power Back Door will not
return. (No return in the engine switch
operation)
The open position of the power back
door can be adjusted.
1 Stop the back door in the desirable
position. (P.109)
2 Press and hold the switch on
the lower part of the back door for
approximately 2 seconds.
When the settings are completed, the
buzzer sounds 4 times.
When opening the back door the next
time, the back door will stop at that posi-
tion.
■ Canceling the adjusted open position of
the back door
Press and hold the switch on the
lower part of the back door for approxi-
mately 7 seconds.
After the buzzer sounds 4 times, it sounds
twice more. When the power back door
does the opening operation the next time,
the door will open to the initial settings posi-
tion.
■ Customization
The opening position can be set with the
center display. (P.572)
Priority for the stop position is given to the
last position set by either the switch
on the lower part of the back door or center
display.
The rear step bumper is for rear end
protection and easier step-up loading.
Adjusting the open position of
the back door
Rear step bumper
To Next Page
Loading...
