283
4-5. Using the driving support systems
4
Driving
to warn the driver, and the vehicle will
slowly decelerate and stop. After the
vehicle stops, the system will enter the
stop and hold phase.
After the vehicle is stopped, the park-
ing brake will be applied automatically.
After entering the stop and hold phase,
the buzzer will continue sounding con-
tinuously and the emergency flashers
(hazard lights) will flash to warn other
drivers of the emergency.
■ Restricted functions after the operation
is canceled
After shifting to the deceleration stop
phase, the following functions will not be
available until the engine is re-started even
though the emergency driving stop system
is canceled:
● LTA
● LCA (if equipped)
● Traffic Jam Assist (if equipped)
*
: If equipped
■ Precautions for use
P.227
Sensors which detect the surround-
ing conditions (P.224)
Sensors which detect the driver
condition (P.225)
■ Situations in which some or all of the
functions of the system cannot operate
P.229
■ Changes in brake operation sound and
pedal response
P.229
■ Situations in which the driver monitor
may not operate properly
P.229
P.281
Stop hold phase
Traffic Jam Assist
*
Traffic Jam Assist is a system which,
through confirmation of the condi-
tions by the driver, provides lane
keeping, accelerating/decelerat-
ing, stopping, and starting off sup-
port on some highways and
expressways. Also, in an emer-
gency, the system can decelerate
and stop, to help avoid a collision or
help reduce the impact of a colli-
sion.
Sensors that support the Traffic
Jam Assist
Emergency Driving Stop System
To Next Page
Loading...
