299
4-5. Using the driving support systems
4
Driving
tor will turn off if the shift position is
changed to R.
When the shift position is R, the intui-
tive parking assist cannot be turned on
or off.
The setting of intuitive parking assist
itself will not change.
■ When towing a trailer
When the 7-pin connector is connected,
the rear sensor automatically turns off.
When reversing, the rear sensors turn off,
but the front corner sensors operate.
■ The system can be operated when
● The engine switch is in ON.
● The intuitive parking assist is on.
● The vehicle speed is less than about 6
mph (10 km/h).
● A shift position other than P is selected.
● Vehicles without the Center Display or
rear camera: The system will automati-
cally turn on (enabled) and the intuitive
parking assist OFF indicator will turn off if
the shift position is changed to R.
The setting of intuitive parking assist itself
will not change.
■ Sensor detection information
● The sensor’s detection areas are limited
to the areas around the vehicle’s front
and rear bumpers.
● Certain vehicle conditions and the sur-
rounding environment may affect the
ability of a sensor to correctly detect an
object.
● Objects may not be detected if they are
too close to the sensor.
● There will be a short delay between
object detection and display. Even at low
speeds, there is a possibility that the
object will come within the sensor’s
detection areas before the display is
■ Cautions regarding the use of the
system
There is a limit to the degree of recogni-
tion accuracy and control performance
that this system can provide, do not
overly rely on this system. The driver is
always responsible for paying attention
to the vehicle’s surroundings and driving
safely.
■ To ensure the system can operate
properly
Make sure to observe the following pre-
cautions. The system may not operate
properly and may lead to an unexpected
accident. When these precautions can-
not be observed, turn the system off.
● Do not damage the sensors, and
always keep them clean.
● Do not attach a sticker or install an
electronic component, such as a
backlit license plate (especially fluo-
rescent type), fog lights, fender pole or
wireless antenna near a radar sensor.
● Do not subject the surrounding area of
the sensor to a strong impact. If sub-
jected to an impact, have the vehicle
inspected by your Lexus dealer. If the
front or rear bumper needs to be
removed/installed or replaced, con-
tact your Lexus dealer.
● Do not modify, disassemble or paint
the sensors.
● Do not attach a license plate cover.
● Keep your tires properly inflated.
● Do not install a suspension other than
a genuine suspension.
■ Notes when washing the vehicle
● When using a high pressure washer to
wash the vehicle, do not spray the sen-
sors directly, as doing so may cause a
sensor to malfunction.
● When using steam to clean the vehi-
cle, do not direct steam too close to
the sensors, as doing so may cause a
sensor to malfunction.
To Next Page
Loading...
