303
4-5. Using the driving support systems
4
Driving
and the detected a static object
does not become shorter, the
buzzer will be muted automatically.
(automatic buzzer mute function)
■ Adjusting the buzzer volume
The buzzer volume of the intuitive parking
assist, RCTA, and RCD (if equipped) can all
be changed at once from the customize
settings. (P.572)
■ Muting a buzzer
When the temporary mute switch is dis-
played on the Center display, this switch
can be pressed to temporarily mute the
buzzer.
Select the switch to mute a buzzer of the
intuitive parking assist, RCTA, and RCD (if
equipped) all together.
● Mute will be automatically canceled in
the following situations:
• When the shift position is changed.
• When the vehicle speed exceeds a cer-
tain speed.
• When there is a malfunction in a sensor
or the system is temporarily unavailable.
• When the operating function is disabled
manually.
• When the engine switch is turned off.
RCTA (Rear Cross Traffic
Alert) function
The RCTA function uses the BSM
rear side radar sensors installed
behind the rear bumper. This func-
tion is intended to assist the driver
in checking areas that are not easily
visible when backing up.
■ Cautions regarding the use of the
system
The driver is solely responsible for safe
driving. Always drive safely, taking care
to observe your surroundings.
The RCTA function is only a supplemen-
tary function which alerts the driver that a
vehicle is approaching from the right or
left at the rear of the vehicle.
As the RCTA function may not function
correctly under certain conditions, the
driver’s own visual confirmation of safety
is necessary.
Over reliance on this function may lead
to an accident resulting death or serious
injury.
■ To ensure the system can operate
properly
P.289
System components
To Next Page
Loading...
