381
4-5. Using the driving support systems
4
Driving
Symptom Likely cause Solution
The screen is difficult to see
The vehicle is in a dark
area or it is night.
The temperature around
the lens is either high or
low
The outside temperature is
low
There are water droplets
on the camera
It is raining or humid
Foreign matter (mud, etc.)
is stuck to the camera
Sunlight or headlights are
shining directly into the
camera
The vehicle is under fluo-
rescent lights, sodium
lights, mercury lights, etc.
Visually check the vehicle’s
surroundings while you are
driving.
Use the Multi-terrain Moni-
tor again once the camera
and conditions have
improved.
The procedure for adjusting
the picture quality of the
Multi-terrain Monitor sys-
tem is the same as the proce-
dure for adjusting the screen
display. Refer to the “MULTI-
MEDIA OWNER’S MAN-
UAL”.
The image is blurry
Dirt or foreign matter, such
as water droplets, snow, or
mud, has stuck to the camera
lens.
Splash the camera with a
large amount of water and
then wipe the camera lens
clean with a soft, damp cloth.
Rear camera (vehicles with
camera cleaning washer):
Operate the dedicated cam-
era cleaning washer and
clean the camera lens.
(P.217)
The screen is misaligned
The camera has received a
strong impact.
Have the vehicle inspected
by your Lexus dealer.
The guide lines are signifi-
cantly misaligned
The camera position is mis-
aligned.
Have the vehicle inspected
by your Lexus dealer.
The vehicle is tilted. (There
is a heavy load on the vehi-
cle, tire pressure is low due
to a tire puncture, etc.)
The vehicle is on an incline.
Visually check the vehicle’s
surroundings while you are
driving.
To Next Page
Loading...
