338
3-4. Using the hands-free phone system (for mobile phones)
Using the call history memory
Follow the procedure below to use a number stored in the call history
memory:
Press the talk switch and say “Redial” (when using a number
stored in the outgoing call history memory) or “Call back” (when
using a number stored in the incoming call history memory).
Select the number by either of the following methods:
a. Say “Previous” or “Go back” until the desired number is dis-
played.
b. Select the desired number using , and .
The following operations can be performed:
Dialing: Press the off-hook switch or select “Dial” using a voice com-
mand or , and .
Storing the number in the phone book: Select “Store” and then
“Confirm” using a voice command or , and .
Deleting: Select “Delete” and then “Confirm” using a voice command
or , and .
■ Call waiting
● If your phone does not support HFP Ver. 1.5, this function cannot be used.
● Call waiting operation may differ depending on your mobile phone and service
provider.
■ Call history
Up to 5 numbers can be stored in each of the outgoing and incoming call history
memories.
■ When talking on the phone
● Do not talk at the same time as with the other party.
● Keep the volume of the incoming voice down. Otherwise, voice echo will
increase.
To Next Page
Loading...
