138
3-3. Adjusting the seats
will be overwritten.
■ Seat positions that can be memorized
(P.135)
The adjusted positions other than the posi-
tion adjusted by lumbar support switch can
be recorded.
■ In order to correctly use the driving
position memory function
If a seat position is already in the furthest
possible position and the seat is operated in
the same direction, the recorded position
may be slightly different when it is recalled.
1 Turn the engine switch <power
switch> to IGNITION ON mode
<ON mode>.
2 Check that the shift position is in P.
3 Press one of the buttons for the
driving position you want to recall
until the buzzer sounds.
■ To stop the position recall operation
part-way through
Perform any of the following:
● Press the “SET” button.
● Press button “1”, “2” or “3”.
● Operate any of the seat adjustment
switches (only cancels seat position
recall).
● Operate the tilt and telescopic steering
control switch (only cancels steering
wheel position recall).
■ Operating the driving position memory
after turning the engine switch <power
switch> off
Recorded seat positions can be activated
up to 180 seconds after the driver’s door is
opened and another 60 seconds after it is
closed again.
■ Registering procedure
Record your driving position to button
“1”, “2” or “3” before performing the
following:
■ Seat adjustment caution
Take care during seat adjustment so that
the seat does not strike the rear passen-
ger or squeeze your body against the
steering wheel.
Recalling a driving position
Registering/canceling/recalling
a driving position to an elec-
tronic key (including a card key)
(memory recall function)
To Next Page
Loading...
