Lexus LC 500h - Detection Range of the Sensors; Sensor Detection Display, Obstacle Distance; When Using Lexus Parking Assist-Sensor

255
4
4-5. Using the driving support systems
Driving
sor may not be detected when
approached, even if they have been
detected once.
• It might be difficult to hear beeps due to
the volume of the audio system or air flow
noise of the air conditioning system.
• It might be difficult to hear beeps due to
the sounds of other systems.
■ Customization
Some functions can be customized.
(P.436)
■ Detection range of the sensors
Approximately 100 cm (3.3 ft.)
Approximately 150 cm (4.9 ft.)
Approximately 60 cm (2.0 ft.)
WARNING
■ When using the Lexus parking assist-
sensor
Observe the following precautions.
Failing to do so may result in the vehicle
being unable to be driven safely and pos-
sibly cause an accident.
● Do not use the sensor at speeds in
excess of 10 km/h (6 mph).
● The sensors’ detection areas and reac-
tion times are limited. When moving
forward or reversing, check the areas
surrounding the vehicle (especially the
sides of the vehicle) for safety, and
drive slowly, using the brake to control
the vehicle’s speed.
● Do not install accessories within the
sensors’ detection areas.
NOTICE
■ When using Lexus parking assist-sen-
sor
In the following situations, the system
may not function correctly due to a sen-
sor malfunction etc. Have the vehicle
checked by your Lexus dealer.
● The Lexus parking assist-sensor oper-
ation display flashes or shows continu-
ously, and a beep sounds when no
obstacles are detected.
● If the area around a sensor collides
with something, or is subjected to
strong impact.
● If the bumper or grille collides with
something.
● If the display flashes or shows continu-
ously without beeping, except when
the mute function has been turned on.
● If a display error occurs, first check the
sensor.
If the error occurs even when there is
no ice, snow or mud on the sensor, it is
likely that the sensor is malfunctioning.
■ Notes when washing the vehicle
Do not apply intensive bursts of water or
steam to the sensor area.
Doing so may result in the sensor mal-
functioning.
Sensor detection display, obsta-
cle distance
A
B
C