56
LC500_LC500h_QG_OM11444U_(U)
1 Turn the engine switch <power switch> to IGNITION ON mode <ON mode>.
2 Press or of the meter control switches and select .
3 Press or of the meter control switches and select “Vehicle Settings”, then
press “OK”.
4 Press or of the meter control switches and select “TPWS SET”, then press
“OK”.
5 Press or of the meter control switches and select “Set tire pressure”. Then
press and hold “OK” until the tire pressure warning light starts blinking.
A message is displayed on the multi-infor-
mation display. Also, “--” is displayed for
inflation pressure of each tire on the multi-
information display while the tire pressure
warning system determines the position.
6 Drive the vehicle at approximately 25 mph (40 km/h) or more for approximately 10 to
30 minutes.
When initialization is complete, the inflation pressure of each tire will be displayed on
the multi-information display.
Initializing the tire pressure warning system
To Next Page
Loading...
