1-3. Adjustable components (seats, mirrors, steering wheel)
Your preferred driving position (the position of the driver's seat and steer-
ing wheel, angle of the outside rear view mirrors, and height of seat belt
shoulder anchor) can be memorized and recalled with the touch of a but-
ton. It is also possible to set this function to activate automatically when the
doors are unlocked.
Three different driving positions can be entered into memory.
The same buttons are found on the front passenger's side, allowing the
front passenger's seat position and seat belt shoulder anchor height to be
memorized.
■ Entering a position to memory
Check that the shift lever is in “P”.
Turn the “ENGINE START STOP” switch to IGNITION ON
mode.
Adjust the driver’s seat, steering wheel, outside rear view mir-
rors and seat belt shoulder anchor height to the desired posi-
tions (When memorizing the front passenger’s seat, adjust the
front passenger’s seat to the desired positions.)
Press the “SET” button, then
within 3 seconds press button
“1”, “2” or “3” until the signal
beeps.
If the selected button has
already been preset, the previ-
ously recorded position will be
overwritten.
To Next Page
Loading...
