Lexus LS500 2024 - Page 118

118
3-3. Adjusting the seats
• The front passenger’s seat belt is fas-
tened.
• The front passenger’s door is open. (The
front seat will not move forward.)
*
: Vehicles with foldable head restraint:
Even when the engine switch is in
ACCESSORY mode or off, the front
passenger seat position and seatback
angle can be adjusted.
● If the rear armrest is stowed while the
seat position is being adjusted, the opera-
tion will stop.
■ Canceling an operation
To cancel an operation, press and hold the
button of the Rear Multi Opera-
tion Panel or press it 3 times in quick suc-
cession.
■ When the front passenger’s seat is
folded forward
P.116
Pneumatic chambers built into the
front seat apply pressure to the occu-
pant’s body at different modes and
intensities.
1 Press the seat switch.
2 Select “Massage” on the center dis-
play.
3 Select the driver’s seat or front pas-
senger’s seat.
4 Select the desired mode.
 “Centripetal”
Applies pressure sequentially from the
front of the seat cushion to top of the seat-
back
 “Centrifugal”
Applies pressure sequentially from the top
of the seatback to the front of the seat
cushion
 “Upper body”
Applies pressure sequentially from the bot-
tom to the top of the seatback
 “Lower body”
Applies pressure sequentially from the
front to the back of the seat cushion
 “Lumbar”
Applies pressure sequentially from the bot-
tom to the top of the lumbar area of the
seatback
5 Select the desired intensity and
then select (on).
The intensity can be adjusted in 5 steps.
To stop the operation, select
(off).
If a seat is not occupied, do not operate the
front seat refresh system for that seat.
■ Refresh system
● Operating conditions
• The engine switch is in IGNITION ON
mode.
• The temperature in the cabin is not
extremely high.
• For the front passenger’s seat: The weight
of an occupant is detected on the front
passenger’s seat or the front passenger’s
seat belt is fastened.
Once weight is detected on the seat, the
Front seat refresh system (if
equipped)