129
3-3. Adjusting the seats
3
Before driving
2 Display the home screen on the
Rear Multi Operation Panel
(P.340) and then touch “Seat”.
3
Touch “Left” or “Right”.
4
Touch “1” or “2”.
When the operating conditions are not
met, the buttons will be grayed out.
To stop the operation touch “STOP”.
If the seat is adjusted while a memorized
position is being recalled, the automatic
operation will stop. (The seat will change to
manual operation.)
■ Operating condition
The weight of an occupant is detected on
the rear seat or the rear seat belt is fas-
tened.
Once weight is detected on the seat, the
seat will be judged as occupied until the
rear door is opened then closed or the
engine switch is turned off.
■ Recalling a rear seat position
If a memorized rear seat position is recalled,
the seat may stop part-way to ensure suffi-
cient space for the rear passenger.
■ Recalling the ottoman position (if
equipped)
When a seat position is recalled, the otto-
man will not raise or extend. The ottoman
position can only be recalled if the memo-
rized position is lower and shorter than the
current position.
Head restraints
Head restraints are provided for all
seats.
Vehicles with power rear seat: The
head restraint for the rear center
seat is integrated into the seatback
and cannot be adjusted.
WARNING
■ Head restraint precautions
Observe the following precautions
regarding the head restraints. Failure to
do so may result in death or serious
injury.
● Use the head restraints designed for
each respective seat.
● Adjust the head restraints to the cor-
rect position at all times.
● Manual type: After adjusting the head
restraints, push down on them and
make sure they are locked in position.
● Do not drive with the head restraints
removed.
To Next Page
Loading...
