EasyManua.ls Logo

Lexus LS500 2024 - Safe Exit Assist

Lexus LS500 2024
572 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
268
4-5. Using the driving support systems
When the difference in speed between
your vehicle and another vehicle is
changing
When a vehicle enters a detection area
traveling at about the same speed as your
vehicle
As your vehicle starts from a stop, a vehi-
cle remains in the detection area
When driving up and down consecutive
steep inclines, such as hills, dips in the
road, etc.
When driving on roads with sharp bends,
consecutive curves, or uneven surfaces
When vehicle lanes are wide, or when
driving on the edge of a lane, and the
vehicle in an adjacent lane is far away
from your vehicle
When an accessory (such as a bicycle
carrier) is installed to the rear of the vehi-
cle
When there is a significant difference in
height between your vehicle and the
vehicle that enters the detection area
Immediately after the Blind Spot Monitor
is turned on
When towing with the vehicle
Instances of the Blind Spot Monitor
unnecessarily detecting a vehicle and/or
object may increase in the following situ-
ations:
When the sensor is misaligned due to a
strong impact to the sensor or its sur-
rounding area
When the distance between your vehicle
and a guardrail, wall, etc. that enters the
detection area is short
When driving up and down consecutive
steep inclines, such as hills, dips in the
road, etc.
When vehicle lanes are narrow, or when
driving on the edge of a lane, and a vehi-
cle traveling in a lane other than the adja-
cent lanes enters the detection area
When driving on roads with sharp bends,
consecutive curves, or uneven surfaces
When the tires are slipping or spinning
When the distance between your vehicle
and a following vehicle is short
When an accessory (such as a bicycle
carrier) is installed to the rear of the vehi-
cle
When towing with the vehicle
Center Display
Safe Exit Assist
The safe exit assist is a system that
uses rear side radar sensors
installed on the inner side of the
rear bumper to help occupants
judge if an approaching vehicle or
bicycle may collide with a door
when exiting, to help reduce the
possibility of a collision.
WARNING
Cautions regarding the use of the sys-
tem
The driver is solely responsible for safe
driving. Always drive safely, taking
care to observe your surroundings.
The safe exit assist is a supplementary
system that, when the vehicle is
stopped, informs occupants of the
existence of approaching vehicles and
bicycles. As this system alone cannot
be used to judge safety, over-reliance
on this system may lead to an accident
resulting in death or serious injury.
In certain situations, this system may not
function to its fullest extent. Therefore it is
necessary for the occupants to visually
check for safety directly and using the
mirrors.
System components
A

Table of Contents

Related product manuals