280
4-5. Using the driving support systems
Object detected by side sensors or side cameras
1
The vehicle is stopped and objects along the sides of the vehicle are not
detected.
2
Objects are detected as the vehicle is moving.
3
Even though the objects are outside of the detection area of the side sensors or
side cameras, a warning is displayed and a buzzer sounds.
■ Object warning function operating con-
ditions
● The vehicle moves about 23.0 ft. (7 m)
after the engine is started.
● The R shift position is selected.
● After the D shift position has been
selected, the vehicle has moved 23.0 ft.
(7 m) or less.
● switch has been pressed and the
Center Display is displayed.
● The front or rear sensor detects a station-
ary object.
■ Detection of objects along the sides of
the vehicle
● Objects along the sides of the vehicle are
not instantaneously detected. The loca-
tion of objects in relation to the vehicle is
estimated after they are first detected by
the front or rear side sensors, or side
cameras. Therefore, after the engine
switch is changed to IGNITION ON
mode, even if an object is along the side
of the vehicle, it may not be detected until
the vehicle has been driven a small
amount and the side sensors or side cam-
eras completely scan the areas along the
sides of the vehicle.
● If a vehicle, person, animal, etc., is
detected by a side sensors or side cam-
eras, but then leaves the detection area of
the side sensors or side cameras, the sys-
tem will assume the object has not
moved.
A
WARNING
■ Side sensors and side cameras
In situations such as the following, the
function may not operate correctly, pos-
sibly leading to an accident. Proceed
carefully.
To Next Page
Loading...
