29
1-1. For safe use
1
For safety and security
■ Customization
Some functions can be customized.
(P.510)
1 Push the seat belt shoulder anchor
down while pressing the release
button .
2
Push the seat belt shoulder anchor
up while pressing the release but-
ton .
Move the height adjuster up and down as
needed until you hear a click.
When the vehicle is subjected to a
severe frontal or side impact or roll-
over, the pretensioners retract the seat
belts of the front seats and rear outer
seats to securely restrain the occu-
pants.
The pretensioners will not operate in minor
frontal or side impacts, or rear impacts.
■ Replacing the belt after the preten-
sioner has been activated
If the vehicle is involved in multiple colli-
sions, the pretensioner will activate for the
first collision, but will not activate for the
second or subsequent collisions.
Adjusting the seat belt shoulder
anchor height (front seats)
WARNING
■ Adjustable shoulder anchor
Always make sure the shoulder belt is
positioned across the center of your
shoulder. The belt should be kept away
from your neck, but not falling off your
shoulder. Failure to do so could reduce
the amount of protection in an accident
and cause death or serious injuries in the
event of a sudden stop, sudden swerve or
accident.
Seat belt pretensioners
A
A
WARNING
■ Seat belt pretensioners
Observe the following precautions to
reduce the risk of injury in the event of
sudden braking or an accident.
Failure to do so may result in death or
serious injury.
● Do not place anything, such as a cush-
ion, on the front passenger’s seat.
Doing so will disperse the passenger’s
weight, which prevents the sensor
from detecting the passenger’s weight
properly. As a result, the seat belt pre-
tensioner for the front passenger’s seat
may not operate in the event of a colli-
sion.
● If a pretensioner has operated, the
SRS warning light will illuminate. In this
situation, the seat belt cannot be used
and must be replaced by your Lexus
dealer.
To Next Page
Loading...
