296
4-5. Using the driving support systems
• The static object is no longer approxi-
mately 6 to 13 ft. (2 to 4 m) away from the
vehicle or in the traveling direction of the
vehicle.
■ Detection range of the Parking Support
Brake function (static objects front and
rear of the vehicle/static objects around
the vehicle)
The detection range of the Parking Support
Brake function (static objects front and rear
of the vehicle/static objects around the
vehicle) differs from the detection range of
the intuitive parking assist (P.276). There-
fore, even if the intuitive parking assist
detects an object and provides a warning,
the Parking Support Brake function (static
objects front and rear of the vehicle/static
objects around the vehicle) may not start
operating.
■ Situations in which the system may not
operate properly
P.274
■ Situations in which the system may
operate even if there is no possibility of a
collision
P.275
■ Situations in which the system may
operate even though there is no possi-
bility of a collision (static objects around
the vehicle) (vehicles with Advanced
Park)
In addition to the situations in which static
objects in front and rear of the vehicle
(P.295) may not be detected, objects
may not be detected by the sensors in the
following situations:
● When moving sideways, such as when
parallel parking (P.312)
■ Detection of objects along the sides of
the vehicle (static objects around the
vehicle) (vehicles with Advanced Park)
● Objects along the sides of the vehicle are
not instantaneously detected. The loca-
tion of objects in relation to the vehicle is
estimated after they are first detected by
the front or rear side sensors, or side
cameras. Therefore, after the engine
switch is changed to IGNITION ON
mode, even if an object is along the side
of the vehicle, it may not be detected until
the vehicle has been driven a small
amount and the side sensors or side cam-
eras completely scan the areas along the
sides of the vehicle.
● If a vehicle, person, animal, etc., is
detected by a side sensors or side cam-
eras, but then leaves the detection area of
the side sensors or side cameras, the sys-
tem will assume the object has not
moved.
To Next Page
Loading...
