424
6-3. Do-it-yourself maintenance
rotation.
Wheel position registration can be
performed by oneself. Wheel position
registration is performed by driving
forward with moderate left and right
turns. However, depending on the driv-
ing conditions and driving environ-
ment, registration may take some time
to complete.
■ Registering the position of each
wheel
1 Park the vehicle in a safe place, turn
the engine switch off and wait 15
minutes or more.
2 Start the engine.
The wheel position registration procedure
cannot be performed while the vehicle is
moving.
3 Select on the center display.
4 Select “Vehicle customize”.
5 Select “Tire pressure”.
6 Select “Tire rotation”.
7 Select “Continue”.
A message indicating that wheel position
registration is being performed will be dis-
played on the multi-information display.
“---” will be displayed for the tire inflation
pressure of each tire and wheel position
registration will begin.
8 Drive straight (with occasional left
and right turns) at approximately
25 mph (40 km/h) or more for
approximately 10 to 30 minutes.
When wheel position registration is com-
plete, a message indicating that registra-
tion has been completed and the inflation
pressure of each tire will be displayed on
the multi-information display.
Even if it is not possible to drive continu-
ously at approximately 25 mph (40 km/h)
or more, registration can be completed by
driving for a long time. However, if registra-
tion does not complete after driving for 1
hour or more, park the vehicle in a safe
place and leave it with the engine switch in
IGNITION ON mode for approximately
15 minutes or more, and then perform the
driving procedure again.
■ When performing wheel position regis-
tration
● Normally, wheel position registration can
be completed within approximately 30
minutes.
● Wheel position registration is performed
while driving at a vehicle speed of
approximately 25 mph (40 km/h) or
more.
■ Wheel position registration procedure
● If the engine switch is turned off while
registering the wheel position, the next
time the engine switch is turned to IGNI-
TION ON mode, the wheel position reg-
istration will resume and it will not be
necessary to restart the procedure.
● While the position of each wheel is being
determined and the inflation pressures
are not being displayed, if the inflation
pressure of a tire drops, the tire pressure
warning light will come on.
■ If the wheel position cannot be regis-
tered easily
● In the following situations, wheel position
registration may take longer than usual to
be completed or may not be possible.
• Vehicle is not driven at approximately 25
mph (40 km/h) or more
• Vehicle is driven on unpaved roads
● If wheel position registration does not
complete after driving for 1 hour or more,
park the vehicle in a safe place for
approximately 15 minutes and then drive
the vehicle again.
● If the vehicle is reversed during wheel
position registration, all data collected
until then will be cleared. Perform driving
again.
To Next Page
Loading...
