280
7-2. Panoramic view monitor
LS500_LS500h_Navi_OM50F66U_(U)
● For details about the front view and the
rear view: →P.265, 273
1 Turn the intuitive parking assist on.
2 Select the area on the panoramic
view display you wish to magnify.
Selecting one of the 2 areas within
the dotted lines will magnify that
area. (Dotted lines are not displayed
on the actual display.)
To return to the normal view, select
the panoramic view display again.
● The magnifying function is enabled when
all of the following conditions are met:
• The wide front view & panoramic
view/Side Clearance View & panoramic
view/rear view & panoramic view/wide
rear view & panoramic view is displayed.
• The vehicle speed is below approxi-
mately 7 mph (12 km/h).
• The intuitive parking assist is available.
● In the following situations, the magnified
display will be canceled automatically:
• The vehicle speed is approximately 7
mph (12 km/h) or higher.
• The intuitive parking assist is unavailable.
● When a sensor indicator on the intui-
tive parking assist display illuminates in
red or a buzzer sounds continuously,
be sure to check the area around the
vehicle immediately and do not pro-
ceed any further until safety has been
ensured, otherwise an unexpected
accident may occur.
Magnifying function
If displayed objects are too small to
see clearly when the panoramic
view is displayed, the area around
the front side or rear side of the
vehicle can be magnified.
Magnifying the display
To Next Page
Loading...
