Lexus LS500 - Things You Should Know

291
7-2. Panoramic view monitor
LS500_LS500h_Navi_OM50F66U_(U)
7
Peripheral monitoring system
If you notice any of the following symptoms, refer to the likely cause and the solu-
tion, and re-check.
If the symptom is not resolved by the solution, have the vehicle inspected by your
Lexus dealer.
Things you should know
If you notice any symptoms
Symptom Likely cause Solution
The image is difficult to see
• The vehicle is in a dark
area
• The temperature around
the lens is either high or
low
• The outside temperature is
low
• There are water droplets
on the camera
• It is raining or humid
• Foreign matter (mud, etc.)
is adhering to the camera
• Sunlight or headlights are
shining directly into the
camera
• The vehicle is under fluo-
rescent lights, sodium
lights, mercury lights, etc.
Back up while visually check-
ing the vehicle’s surround-
ings. (Use the monitor again
once conditions have been
improved.)
The procedure for adjusting
the picture quality of the pan-
oramic view monitor system
is the same as the procedure
for adjusting the screen dis-
play. (→P.55)
The image is blurry
Dirt or foreign matter (such
as water droplets, snow, mud,
etc.) is adhering to the cam-
era.
Flush the camera with a large
quantity of water and wipe
the camera lens clean with a
soft and wet cloth.
The image is out of alignment
The camera or surrounding
area has received a strong
impact.
Have the vehicle inspected
by your Lexus dealer.