Lexus LS500h - Some Basics

107
4-1. Basic operation
LS500_LS500h_Navi_OM50F66U_(U)
4
Audio/visual system
■ Certification
CAUTION:
THIS PRODUCT IS A CLASS LASER
PRODUCT. USE OF CONTROLS OR
ADJUSTMENTS OR PERFORMANCE
OF PROCEDURES OTHER THAN
THOSE SPECIFIED HEREIN MAY
RESULT IN HAZARDOUS RADIATION
EXPOSURE. DO NOT OPEN COVERS
AND DO NOT REPAIR BY YOURSELF.
REFER SERVICING TO QUALIFIED
PERSONNEL.
“PWR/VOL” knob: Press to turn the
audio/visual system on and off. The sys-
tem turns on in the last mode used.
Turn this knob to adjust the volume.
 A function that enables automatic
return to the previous screen from
the audio/visual screen can be
selected. (→P.53)
 Using the audio control switch
1 Press the “RADIO” or “MEDIA”
button.
“RADIO” button: Press to change
radio modes.
“MEDIA” button: Press to change
media modes.
 Each time the “RADIO” or
“MEDIA” button is pressed, the
audio source changes.
 From the audio source selection
screen
1 Display the audio control screen.
2 Select “Source” on the sub menu.
3 Select the desired source.
● Dimmed screen buttons cannot be oper-
ated.
● When there are two pages, select or
Some basics
This section describes some of the
basic features of the audio/visual
system. Some information may not
pertain to your system.
Your audio/visual system works
when the engine switch <power
switch> is in ACCESSORY or
IGNITION ON mode <ON mode>.
NOTICE
● To prevent the 12-volt battery from
being discharged, do not leave the
audio/visual system on longer than
necessary when the engine is not run-
ning <hybrid system is not operating>.
Turning the system on and off
Selecting an audio source